The DRIP pipe Ø 16 mm, the distance between the emitters 60 cm, 2.5 litres/year – WATER DRIP – 200 m, DSWWD161160-250-200Drip irrigation pipe (solution). Internal diameter: 16 mm Wall thickness: 1.1 mm Working pressure: 0.7-2.0 Bar Distance between emitters: 60 cm Waterproof: 2.5 litres/year per droplet Length in the bay: 200 m The emitters, built into the tube, compensate for the pressure through a special labyrinth through which the movement of WATER to the droplet takes place. As the length of the irrigation line increases, the pressure decreases but slightly. In places where the emitters are located, the tube has an enlarged diameter, which prevents the droplets from squeezing. The DRIP irrigation pipe is made of high-quality primary polyethylene, resistant to the negative effects of ultraviolet and light chemicals. It is resistant to root rot and insect damage. A DRIP pipe is used similarly to a DRIP tape, but is more durable: it can be dismantled at the end of the season, and installed in the New Year. It is also possible to leave the pipe in the field for the winter period, prior to pouring WATER from the system. A DRIP irrigation pipe is widely used for drying perennials, orchards, roses. Using DRIP drying systems – is a smart approach to irrigation. This method of irrigation allows WATER to be pumped directly into the root zone of the plant for a long time. To mount the WATER DRIP drop tube, you'll need a 16 mm joint.